Blind Nailing Siding

To ensure that the nail gets into the groove where it will be hidden it must be inserted at an angle.

Blind nailing siding.

You are much better off face nailing with stainless steel 5d or 6d ring shank siding nails. Beveled clapboard siding unless you were going to expose only 3 in. I wouldn t recommend blind nailing 1 2 in. Fasteners will be exposed on siding located immediately below window sills fascia boards and horizontal trim.

It also prevents problems with cracking and warping. With tongue and groove paneling the nails are inserted into the groove and hammered to below the surface. Be sure to drive nails at least 3 8 from butt ends or use manufacturer specified joiners. Blind nailing nailing through top of plank blind nailing is recommended for installing any type of hardieplank lap siding including colorplus siding.

Fasteners shall be installed between 1 in. With blind nailing each course covers the fasteners on the course below which provides a better looking installation. Blind nailing preferred installation james hardie prefers and recommends installation of hardieplank lap siding by the blind nailing technique such that fasteners are hidden by the course above. From the ends of the plank.

From the top edge and no closer than 3 8 in. Blind nailing refers to nailing each board one at a time and then overlapping that nailed layer with the next board so that all nails are hidden. For blind nailing hardieplank lap siding james hardie recommends driving. Siding shall be installed with top blind nailing with the nails placed 3 8 inch 10 mm from either end and a minimum of 3 4 inch 19 mm from the top edge of the board.

Keep blind nails between and 1 from the top edge of the panel figure 10. If you want to learn more about siding repairs and replacement findlay roofing can help. Fasteners below window sill.